Filter
Top Products
Removing and Replacing Parts 4-17
4. Disconnect all internal power harnesses and cables from the PSPB.
5. Remove the front bezel.
6. Remove the five screws securing the PSPB cover plate to the left side of
the chassis and remove the cover plate (see Figure 4-13).
7. Loosen the two captive Phillips screws (one internal screw that secures
the PSPB to the floor of the chassis and one external screw that secures
the PSPB through the front of the chassis).
8. Disconnect the AC routing cable from the PSPB.
9. Slide the PSPB assembly out of the chassis.
When replacing the power harnesses and cables, refer to “PSPB and System
Power Supplies” in Chapter 1 for cable routing information.