Filter
Top Products
Removing and Replacing Parts 4-23
7HUPLQDWRU&DUWULGJH
To remove a terminator cartridge, follow these steps:
1. Press outward on the two SEC cartridge release latches until they snap
into the open position (see Figure 4-19).
2. Pull the terminator cartridge straight up out of the connector and guide
bracket assembly (some force may be required).
To install a terminator cartridge, make sure the cartridge release latches are in
the open position, orient the terminator cartridge in the guide bracket assem-
bly as shown in Figure 4-19, seat it firmly, and then snap the release latches
back into place.
terminator
cartridge
guide bracket
assembly
release
latches (2)