Filter
Top Products
4-14 Dell PowerEdge 6350 Systems Service Manual
6\VWHP3RZHU6XSSOLHV
To remove a power supply, follow these steps:
1. Disengage the power supply handle from the latched position by pressing
down on the handle at the “press here” symbol and then releasing it (see
Figure 4-11).
2. Rotate the handle upward and then pull up on it to slide the power supply
out of the chassis.
To install a power supply, align the front and rear tabs on the power supply
with the slots in the chassis and slide the new power supply into the chassis.
Then rotate the power supply handle to the closed position, and press it down
until it snaps into place.
When the handle is fully closed, it activates a switch that notifies the PSPB
that the power supply is installed and can be turned on.
power supply handle
power supply
chassis slots
(one each side)
power supply switch
“press here” symbol