Filter
Top Products
Community Property Groups | 117
Setup Guide
To create a Community Property Group
1 Administration > Network configuration > Community Property Group >
Add a community property group.
2 Give a name to the Community Property Group. Use a name that is
meaningful to you.
3 Add a description.
4 Under the heading Add a Community String enter a string name, and select
the appropriate Type (read or write, or both).
5 Click Add.
6 Repeat steps 4 and 5 for each community string that can be applied to the
same set of devices or subnets.
7 If necessary, select a community string and click the Move Up or Move
Down buttons to move it to the right place.
When you add community strings, the order is important, make sure the
most frequently used strings are at the top of the list.
8 Click Submit.
To apply the Community Property Group to the IPv4 range
1 Click Administration > Network configuration > Add IPv4 range.
2 Click Add by interval and enter the starting and ending IPv4 addresses for
the range you want.
3 In the Choose existing Property Set/Group drop-down list, select the name
of your newly created Community Property Group.
4 Click Submit.