Filter
Top Products
56 | Install and Start Network Discovery
Network Discovery
Give the Peregrine appliance its network information
Working with the configuration interface, you will enter the IPv4 address of the
Peregrine appliance, the network mask (also called a netmask), and the IP
address of the gateway. This information is on your completed Pre-setup
Questionnaire. Until the information is entered, the Peregrine appliance will not
be reachable from the network.
To log in to Network Discovery through the configuration interface
On the terminal or monitor connected directly to the Peregrine appliance, the
screen shows:
Press Enter to access the Configuration menu.
1 Press Enter.
The screen shows:
Password:
2 Type Appliance.
The “A” is uppercase.
3 Press Enter.
To use the configuration interface to give the Peregrine appliance its
network information
The screen shows the Appliance Management menu:
1) Settings
2) Actions
3) Appliance hardware information
4) Exit and log off
4 Type 1 (or use the arrow keys to move the cursor to 1) and press Enter.
The screen show the Appliance Settings menu: