Filter
Top Products
DI-1162/DI-1162M Remote Access Router
21
WAN Frame Relay Config
This screen allows you to specify which WAN 1 or WAN 2 Frame Relay is to be configured by highlighting the
desired entry below and then hitting <Enter>. Next, enter a Data Link Connection Identifier (DLCI) between 16
and 991 and
Enable
it in the State field on the following screen. Additionally, you must choose the appropriate
Switch Type on the
WAN Frame Relay Config
screen below to complete the WAN Frame Relay configuration.
The parameter is described below:
♦
Switch Type –
This allows you to choose Local Management Interface (LMI) specification. Currently, we
support ANSI T1.617 Annex D and ITU Q.933 Annex A specifications. This switch type must be configured to
match your Frame Relay subscription. Once a change has been made, the router must be rebooted.