Filter
Top Products
DI-1162/DI-1162M Remote Access Router
26
3.
Talk
– The router will send adjacent routers it’s own routing table, but will not incorporate routing
information from them.
4.
Both
– The router will incorporate routing information from adjacent routers, and will send adjacent
routers it’s own routing table.
♦
IP Multicasting –
This feature enables or disables the router’s ability to perform IP multicasting. When
enabled, the router will perform IGMP. It can also perform DVMRP if this feature is enabled below.
♦
Multicast Protocol –
If this parameter is set to
None
, the router will only use the Internet Group Management
Protocol (IGMP). If it is set to
DVMRP
, the router will also use the Distance Vector Multicast Routing
Protocol (DVMRP).
♦
IGMP Version –
Configures the router to use either IGMP version 1 or 2.
♦
DHCP Client (LAN)
– This feature allows the LAN port to be assigned an IP address from a DHCP server
other than the one in the router. This feature should be enabled only for special configurations (such as the
presence of a cable modem on the LAN) where you wish the router to work with a device on the network that
must act as a DHCP server. Otherwise, this feature should be kept disabled.
♦
RIP Spoofing
(WAN)
– This feature should only be enabled if you have more than one router on your network
and this router is providing your WAN connection. In this case, if the WAN connection is dropped due to
inactivity and this feature is enabled, RIP packets will be sent to the other routers on the network telling them
that data can still be sent to the WAN via this router. Otherwise, the other routers will learn that the WAN link
has been disconnected and will no longer forward packets destined for the WAN to this router, causing the
packets to be dropped before Bandwidth on Demand has a chance to reestablish the WAN connection.
WAN Frame Relay IP Config
If
FRAME_RELAY
is selected for the Protocol on
WAN 1
or
WAN 2
under
Interface Configuration
, the
following screen will appear:
The descriptions for all the fields are the same as in the previous section. Select one of the Frame Relay IP Config
items at the bottom of the screen to access the following screen: