Filter
Top Products
1
firmwareRestore
1-169
Telnet Commands
firmwareRestore
Restore old active firmware image from the secondary partition.
Syntax
firmwareRestore
Availability Admin
Description Use this command to restore the old active firmware image. This is
only possible if the last firmwaredownload was not committed.
After a
firmwaredownload and a reboot, the downloaded firmware
will become active. If you then do not want to commit the firmware,
and instead want to restore the old firmware, run
firmwareRestore.
After running
firmwareRestore, you can run firmwareDownload
again.
This command will reboot the system and make the old firmware
active. After reboot, both active and backup images should be
restored to the old firmware.
This command will only take action if the system is booted after a
firmwaredownload. Otherwise, it will return with an error code.
Operands None
Example
To restore old active firmware image:
switch:admin> firmwarerestore
Restore Kernel Image...
................................
switch:admin>
See Also firmwareDownload
firmwareCommit