Filter
Top Products
In order to match your printing to the output produced on an
HP LaserJet series IIP or III printer, you can use the T-OFFSET
and L-OFFSET feature of the SYSTEM CONFIG. option in
SelecType Level 1 to make fine adjustments to the print start
position. However, because the offset feature can move the
printing position to a point outside of the printable area, some
of the data may not be printed. See Chapter
4
for more
information on SelecType.
Character dipping
If a character is partially outside the printable area, the HP
LaserJet clips it and the part outside of the printable area is not
printed.
Paper handling
When using the printer in HP emulation, the paper size is not
determined by the paper bin or cassette as it is with an HP
LaserJet printer. Use the PAGE SIZE option in SelecType
Level 1 to set any of the fourteen paper sizes supported by the
printer. For certain nonstandard sizes of paper, you may need
to use the single sheet feed option described in Chapter 2.
Operating the printer as an HP LaserJet IllSi
Your ActionLaser 1500 uses HP emulation to operate as an HP
LaserJet IIISi. If your application software does not list the
ActionLaser 1500 on its printer menu but does list the HP
LaserJet IIISi, choose the LaserJet IIISi instead of the LaserJet III
to take advantage of all of your printer’s features.
B-4
HP Emulation Mode