Filter
Top Products
INTERFACE
This Level 2 option allows you to change settings for the
built-in interfaces, parallel and serial. This option is not
available for channel 0.
Menu/submenu
4
INTERFACE
Available options
b P (Parallel)
S (Serial) (ActionLaser 1500 only)
The PARALLEL option has these three submenus:
Menu/submenu
4
CH P CONFIG.
Available options
b
SLCTIN
AUTOFEED
BUSY DELAY
Normally, you do not need to change these settings. Change
them only when you have special requirements.
SLCT-IN-When you set SLCT-IN to OFF, the printer is
continuously selected and ignores device control codes DC1
and DC3. In almost all cases, leave SLCT-IN set to OFF. When
SLCT-IN is ON, the SLCT-IN signal goes HIGH at power-on
and the control codes DC1 and DC3 are valid.
Menu/submenu
Available options
4
SLCT-IN
OFF
b
ON or OFF
AUTOFEED-When you set AUTOFEED to OFF, the printer
ignores the AUTOFEED signal on pin 14 and does not send an
automatic line feed (LF) command with each carriage return
(CR). When you set AUTOFEED to ON, the printer adds a line
feed to each carriage return it receives. If your text lines
overprint each other, set AUTOFEED to ON.
Menu/submenu
:
AUTOFEED
Available options
OFF
b
ON or OFF
4-14 SelecType