Filter
Top Products
Stylus C40UX/C40SX/C20UX/C20SX Revision A
Troubleshooting Troubleshooting with LED Error Indications 52
Table 3-16. Paper is not ejected completely without any error indication
Step
No.
Detail phenomenon Check point Remedy
1
Printing is normal. But,
the paper is not ejected
completely and the
bottom area stay around
the Paper eject frame.
1. Check if the Paper eject
roller rotate when the
paper is ejected.
2. Check if the Paper eject
frame is secured with
the three fixing screws
to the Main frame.
1. Assemble the Spur gear
60 to the PF motor pinion.
2. Secure the Front frame
with the two fixing screws
to the Main frame.
Front frame
Screws
Spur gear 60
PF motor pinion
Table 3-17. Dot missing occur and it is not recovered with CL
Step
No.
Detail phenomenon Check point Remedy
1
In the CL sequence, the
pump unit seems work
correctly. But, ink is
not ejected to the waste
ink pad at all.
Moreover, any ink is not
absorbed from the head
to the cap.
1. Check if ink is ejected
to the waste ink pad via
pump unit in the CL
sequence.
2. Check if there is any
foreign material around
the seal rubber parts on
the cap assembly.
3. Check if any damage is
observed around the
seal rubber parts on the
cap assembly.
4. Check if the
compression spring
is assembled in the Cap
assembly correctly.
1. If ink is not ejected at all
to the waste ink pad in the
CL sequence, proceed the
following check point 2).
2. Remove the foreign
material around the seal
rubber parts.
3. Replace the Printer
mechanism with new one.
4. Replace the Printer
mechanism with new one.
Cap seal rubber parts
Compression
spring