Filter
Top Products
Stylus C40UX/C40SX/C20UX/C20SX Revision A
Disassembly and Assembly Disassembly 71
4.2.8 Printhead unit removal
1. Remove the upper housing. (Section 4.2.1 Upper housing removal)
2. Remove the ink cartridges.
3. Move the carriage to the center.
4. Press on the driven pulley and loosen the timing belt, then remove the timing belt
from the CR pinion gear.
Figure 4-26. Removing the Timing belt
5. Disconnect the FFC from the carriage unit.
Figure 4-27. Disconnecting the FFC
6. Press on the left and right inside of the carriage unit, then pull the unit forward and
remove the cover.
Figure 4-28. Removing the Carriage cover
7. Lift the Printhead unit up and remove it.
Figure 4-29. Removing the Printhead unit
CR pinion gear
Timing belt
Driven pulley
FFC
Carriage unit
Carriage cover
Printhead unit