Filter
Top Products
Stylus C40UX/C40SX/C20UX/C20SX Revision A
Adjustment Overview 87
5.1.11 Refurbishment for DOA
If you clean the cavity of the printhead and cap assembly, this function will be useful.
1. Choose the “Refurbishment for DOA” in the Maintenance menu.
Figure 5-21. Choose the Refurbishment for DOA menu
2. Set the dummy cartridge in the printer using the ink replacement function.
3. Select “Yes” under “Item,” then click the “OK” button. The “Refurbishment for
DOA” function is then executed.
C A U T I O N
After carry out this function, replace the waste drain ink pad
with new one and reset the Waste drain ink pad counter.
Otherwise, the ink or S46 liquid may leak from the pad during
the transportation.
Prepare the following tool.
*Dummy ink cartridge, Injector, S46 liquid
Do not carry out this program repeatedly. This operation is
available only one time. Excessive operation causes overflow of
the ink and S46 liquid.
When you refurbish the repair product by using this program,
do it on your responsibility.
When you charge S46 liquid into the dummy ink cartridge with
the Injector, make sure fill out the dummy ink cartridge with S46
liquid. In case enough S46 liquid is not charged into the dummy
cartridge, the printhead will not cleaned and not filled with the
S46 liquid enough in this operation.
Keep the S46 liquid and the dummy ink cartridge clean.