Filter
Top Products
5-116
116 | Maintaining and Transporting the Printer
Performing Additional Maintenance Tasks
In addition to running a power cleaning cycle and replacing the cutter blade,
you can use the Maintenance menu to set the printer’s date and time. You
can also use the maintenance mode to change printer defaults and run
special procedures.
Changing the Date and Time
Follow these steps to set the date and time:
1. Press the
Menu button.
2. Press the button until you see
MAINTENANCE, then press Menu
again.
3. Press the button until you see
CLOCK SETTINGS, then press Menu
.
4. Use the or buttons to set each item in the date and time, displayed
in the following format:
MM/DD/YY HH:MM.
Using the Maintenance Mode
The maintenance mode allows you to make special settings and perform
maintenance procedures that may be needed occasionally. You can use the
maintenance mode to do the following:
• Print a hex dump for diagnosing problems
• Change the language or units of measurements used on the printer’s
control panel menus
• Enable the printable pages counter
• Change the default pressure setting for the automatic cutter
• Run a “super strong” cleaning cycle.
• Return all of the printer’s control panel settings to their default values
sp4800Guide.book Page 116 Monday, May 9, 2005 10:49 AM