Filter
Top Products
6-131
Solving Problems | 131
When your ink or paper runs out or a problem occurs, a message appears on
the LCD display, and the lights on the control panel come on or flash. The
following table lists the messages in alphabetical order and includes an
explanation and instructions for correcting the problem.
Message Light Explanation Response
CHANGE PAPER
TYPE
Paper light
on
Paper loaded does not
match the source
selected.
Press the
Paper Source button to select the
correct setting: either (for paper in the tray,
or
or for roll paper).
COMMAND
ERROR
— You’re using the wrong
printer driver.
Damaged data was
sent to the printer or
the data has an
incorrect command.
The installed printer
driver is not correct for
the printer.
Press the
Pause button and hold it for 3
seconds to cancel the print job. Make sure you
installed the correct driver for your printer.
Press the Pause button and hold it for 3
seconds to cancel the print job.
Stop printing, and press the
Pause button for
3 seconds. Then make sure that the installed
printer driver is correct for the printer.
DRIVER INK SET
SETTING IS
WRONG
MISMATCH
ERROR
Note:
These messages
alternate.
— The black ink cartridge
option does not match
what is selected in the
driver
Non-Epson genuine ink
cartridge is installed.
Stop printing, and then press and hold the
Pause button for 3 seconds. Select the correct
black ink cartridge option in the driver. See
page 115. If you want to continue printing,
press the
Pause button.
Press the Pause button for 3 seconds to
cancel printing. If you want to continue printing,
press the
Pause button.
FEED SHEET
PAPER
FEED SHEET
PAPER
MANUALLY
— Cut sheet needs to be
loaded manually.
Load the sheet in the manual feed slot. See
page 46 for instructions.
FORBIDDEN
MEDIA FROM P.
TRAY
— Cut sheet needs to be
loaded manually.
Load the sheet in the manual feed slot. See
page 46 for instructions.
INK LOW B Ink light
flashing
Ink cartridge(s) are
nearly empty (printing
continues).
Make sure you have replacement cartridges
available. See page 108.
INK OUT B Ink light on Ink cartridge(s) are
empty (printing stops).
Replace the ink cartridge(s) indicated on the
LCD panel. See page 108 for instructions.
sp4800Guide.book Page 131 Monday, May 9, 2005 10:49 AM