Filter
Top Products
5-117
Maintaining and Transporting the Printer | 117
Follow these steps to use the maintenance mode:
1. Make sure the printer is turned off. Press and hold the
Pause button,
then press the P Power button until the printer turns on and displays
HEX DUMP on the LCD panel.
2. Press the or button to select the settings described below. If you
need to back up to the previous menu level, press the button.
• To print a hex dump of data in the printer’s buffer, press the
Menu
button to display EXEC. Then press Menu again
to print the 16-byte hex data in the left column and corresponding
ASCII characters in the right column. Press the
Pause button to
print the last page.
• To change the language displayed on the LCD panel, press the
button until you see
LANGUAGE, then press the Menu button.
Press the button until you see the language you want, then press
Menu again to select it. The printer exits maintenance mode
and returns to normal operation.
• To enable printable pages, press the button until you see PAPER
COUNTER
, then press the Menu button. Press the button to
select an option, then press the
Menu button.
• To change the units of measurement, press the button until you
see
UNIT, then press the Menu button. Press the button to
switch from
METER to FEET/INCH, then press Menu to select
the units you want. Press the button when done.
• To change the default cutting pressure, press the button until you
see
CUT PRESSURE, then press the Menu button to display
100%. Press the button to decrease the pressure, or the button
to increase it (in 1% increments). Press
Menu to select the
setting you want.
• To run a super strong cleaning cycle, press the button until you
see
SSCL, then press the Menu button to display EXEC. Press
Menu to start the cleaning cycle.
• To return all control panel settings to their default values, press the
the
button until you see DEFAULT PANEL, then press the
Menu
button to display EXEC. Press Menu again to restore
the default settings.
sp4800Guide.book Page 117 Monday, May 9, 2005 10:49 AM