Filter
Top Products
1-24
24 | Setting Up the Printer
Before you install the print server, make sure you check the documentation
included with the card for additional instructions. Then follow these steps to
install the card:
1. Turn off your computer and printer.
2. IMPORTANT: Unplug the printer from its electrical outlet. Not doing
so may cause damage to the printer and the card.
3. Disconnect any interface cables from the printer.
4. Use a cross-head screwdriver to remove the two screws securing the
optional interface cover. Then lift off the cover as shown:
Make sure you keep the screws in case you need to remove the card and
replace the cover.
5. Slide the card along the slots inside the compartment. Push it in firmly
to fully insert the connector into the printer’s internal slot.
6. Use the two screws included with the card to secure it.
7. Connect one end of the appropriate cable to the card. Then connect the
other end to your computer’s Ethernet port or hub.
Caution: You must
unplug the printer from
the power outlet, or you
may damage the printer
and the card.
Note: You need to
remove the card when
shipping the printer. See
page 127.
sp4800Guide.book Page 24 Monday, May 9, 2005 10:49 AM