Filter
Top Products
142
Chapter 5 Operations after OS Installation
1 Turn on the server and insert the "Server Management Tools" disk into the
floppy disk drive.
2 When the DOS prompt window appears, enter the following command and
press the [Enter] key.
A:\SMTOOL\>biosrest.bat
3 The following procedures differ depending on the BIOS setting to be restored.
When the network startup (PXE) is disabled (disabled at the time of purchase)
If the BIOS information is restored correctly, the following message appears.
When the network startup (PXE) is enabled
The following message appears.
In this case, the BIOS information restoration procedure must be performed twice.Restart the
server and perform Steps 1 and 2.
When the BIOS information is set correctly, the following message appears again.
4 The BIOS information will be enabled after the next system restart. Restart the
server.
Perform Step 1 to display the DOS prompt window. The restoration procedure has been
completed. The server can now be turned off safely.
Success!
Success!
-----------------------------------------------
Execute 'biosrest.bat' twice in order to restore
BIOS settings completely.
Please run 'biosrest.bat' again after a reboot,
if this operation is the first time.
-----------------------------------------------
Success!
-----------------------------------------------
Execute 'biosrest.bat' twice in order to restore
BIOS settings completely.
Please run 'biosrest.bat' again after a reboot,
if this operation is the first time.
-----------------------------------------------