Filter
Top Products
261
PRIMERGY RX200 S2 User’s Guide
9
Operation and Maintenance
■ Error Window Appears after Installation or Uninstallation of
ServerView or RAID Management Tool (Global Array Manager) on
Windows Server 2003
Systems with Windows Server 2003 Service Pack 1 may display the following popup message at the
next startup after installation or uninstallation of ServerView or RAID Management Tool. This is not a
problem. Click [Close message] to close the message.
■ Error Messages during Installation
The following error messages may appear during installation using ServerStart. Check the corrective
action against the relevant error.
● "WzDiskAdmin: System Error! ---------------, Last Error: The device is not
ready." appears.
External devices (e.g., hard disk cabinet) may be connected. Disconnect the optional SCSI devices and
perform installation again. Connect the optional devices after the installation completes.
● "WzDiskAdmin: Partition detected! Please delete all partition before starting
Configuration" appears.
Run the guide or preconfiguration mode again. Check [Delete all partitions on the displayed disk] in the
disk wizard.
● "WzRaid: RAID arrays detected! Please delete all RAID arrays before starting
Configuration" appears.
Use the ServerStart floppy disk you have created. Check [Delete existing RAID array] or select [Use
existing array] in the RAID wizard.
● "Operating System not found" appears when the system restarts after file
copy from the CD-ROM.
The possible causes are as follows:
• The RAID card comes earlier than the onboard SCSI array card in order of device startup.
• The Active flag is specified.
● "Missing Operating System" appears during installation.
The installation partition size may be too large. Specify the installation partition size correctly.
For details on the installation partition size, refer to "2.3.1 Installation Partition Size" (
pg.45).
● "Error 1920. Service (PXE Services) failed to start" appears during
preconfigured installation.
The system installed with the preconfigured settings (PXE server) may not be connected to the network.
Check the LAN cable connection and click [Rerun].
Windows has terminated the following program to prevent damage to your
computer.
Name: SNMP Service