Filter
Top Products
48
Chapter 2 Checking before OS Installation
2.3.5 Expansion Cards Supported by ServerStart
ServerStart supports automatic driver installation for the following expansion cards.
2.3.6 Cautions for Manual Installation
■ Cautions for Configuring a Disk Array with an Onboard SCSI Array
Controller
Disk array configuration on the onboard SCSI array controller must be completed before the OS is
installed. To check the onboard SCSI array controller configuration, start up the SCSI Setup Utility. For
more details, refer to "8.3 SCSI Setup Utility" (
pg.233).
If a disk array is not configured on the onboard SCSI array controller, the normal SCSI configuration is
established.
■ Free Space Required for Installation
The partition where the OS is installed must have enough free space for obtaining memory dump. For
more details, refer to "5.1 Memory Dump/Paging File Setting" (
pg.128).
■ Cautions on Restarting
In the course of installation, a message appears to indicate that the setup program restarts. Wait until it
restarts.
For more details on background operations, refer to "PRIMERGY RX200 S2 Onboard SCSI RAID
User's Guide".
table: Automatic Expansion Card Driver Installation
Name Model Bus
Onboard FDD/IDE - -
Onboard SCSI - PCI
Onboard LAN - PCI
Onboard VGA - PCI
RAID Ctrl 2-Channel 128 MB w/ BBU PG-142E3 PCI
Fibre Channel Controller PG-FC106 PCI
LAN cards PG-1852 PCI
PG-1862 PCI
PG-1882L PCI
PG-1892L PCI
SCSI Ctrl U160 lp PG-130L PCI