Filter
Top Products
225
PRIMERGY RX200 S2 User’s Guide
8
Hardware Configuration/Utilities
Mode • Continue (at the time of
purchase)
• Reset
•Power Cycle
Sets the operation to be performed when a timeout
occurs during OS boot monitoring.
• Continue: The boot sequence is continued.
• Reset: The server restarts automatically and starts
POST.
• Power Cycle: The server turns off automatically.
The server turns on automatically after the time
specified in [Power cycle Delay].
Timeout Value • 0 (at the time of
purchase)
• 1-100
When [O/S Boot Timeout] is set to [Enabled], the
system restarts automatically if the OS fails to start
up within the time set for this item.
ASR&R Boot Delay (min) • 2 (at the time of
purchase)
•1-30
Sets the standby time for startup after shutdown due
to trouble (such as overheating) in minutes. The
system restarts after the set standby time.
Power Cycle Delay 5 (Fixed parameter) Sets the time until the server is turned on after it is
turned off.
Boot Retry Counter • 3 (at the time of
purchase)
•0-7
Sets the maximum number of OS startup retries.
Diagnostic System Disabled (Fixed
parameter)
Sets the operation to be performed when the number
of system boot retries exceeds the number specified
in [Boot Retry Counter].
Critical Temperature
Monitoring
Disabled (Fixed
parameter)
Sets whether or not to turn the power off in the event
of abnormal temperature.
Memory scrub Enabled (Fixed parameter) Sets whether or not the BIOS detects and corrects
memory errors.
BIOS runtime logging Enabled (Fixed parameter) Sets whether or not the CPU, memory, or PCI slot
errors are recorded in the error log.
Clear Screen Delay (sec) • 5 (at the time of
purchase)
•0-31
Sets the time (seconds) to display the last BIOS
message screen before the OS starts up.
IPMI [Enter] Configures the Baseboard Management Controller
(BMC).
"8.2.12 IPMI Submenu" (pg.226)
CPU Status [Enter] Displays whether or not to allow the use of the
installed CPU.
"8.2.13 CPU Status Submenu" (pg.227)
Memory Status [Enter] Sets whether or not to allow the use of the installed
memory.
"8.2.14 Memory Status Submenu" (pg.228)
LAN Setting [Enter] Sets the LAN for remote operations with Remote
Control Service.
"8.2.15 LAN Setting Submenu" (pg.229)
Console Redirection [Enter] Configures detailed settings for console redirection.
"8.2.16 Console Redirection Submenu" (pg.230)
table: Items on the Server Menu
Item Setting Description