Filter
Top Products
13–4 MULTILINK ML1200 MANAGED FIELD SWITCH – INSTRUCTION MANUAL
RAPID SPANNING TREE PROTOCOL CHAPTER 13: RAPID SPANNING TREE PROTOCOL
13.2 Configuring RSTP through the Command Line Interface
13.2.1 Normal RSTP
The commands to setup and configure RSTP are as follows. The set stp command sets
the switch to support RSTP or STP. It is necessary to save and reboot the switch after this
command.
set stp type=<stp|rstp> -
The
rstp command enters the RSTP configuration mode and enables/disabled RSTP. By
default, RSTP is disabled and has to be manually activated.
rstp
rstp <enable|disable>
The syntax for the
port command on RSTP is shown below.
port port=<number|list|range> [status=<enable|disable>] [migration=<enable>]
[edge=<enable|disable>] [p2p=<on|off|auto>]
The
p2p parameter sets the “point-to-point” value to off on all ports connected to shared
LAN segments (i.e. connections to hubs). The default value is
auto. P2P ports would
typically be end stations or computers on the network.
The
edge parameter enables/disables all ports connected to other hubs, bridges and
switches as edge ports.
The
migration parameter is set for all ports connected to devices such as hubs, bridges
and switches known to support IEEE 802.1d STP services but not RSTP services
The
show active-stp command displays whether STP or RSTP is running.
show active-stp
The
show stp command display the RSTP or STP parameters.
show stp <config|ports>
Note
Users may notice extended recovery time if there is a mix of firmware revisions in the Mesh
or Ring