Gilson 215 Robotics User Manual


 
2-8
Installation 2
Plumbing Connections
Installing the Level Sensing Cables
To install the level sensing cable:
1 Plug the right-angle connector on one end of the
cable into socket one on the back of the Z-arm.
2 Snap the cable into the LLD cable guide (refer
to the picture above).
3 Loosen the small hexagonal nut on the probe
holder for probe one. Attach the split-tongue
connector to the nut. Retighten the nut until
snug (approximately one turn after finger
tightening).
4 Repeat for probes 2 through 4.