Filter
Top Products
System Administrator Screens
312353B 47
Removing a Meter
In the Action column of the meter to be removed from
the screen, click Remove. The meter is removed from
the Meter Setup screen. This action will permanently
delete the meter’s dispense history.
Meter Programming
New meters need to be programmed with the meter
setup information. However, anytime information is
changed in the existing Meter Setup screens (except for
the meter name), the corresponding meter must be
reprogrammed.
1. On the Meter Setup screen at the PC, locate the
meter that is to be programmed.
2. Click that Meter’s Program Link. This puts the PC
in program mode for that meter. You are prompted
with the screen shown in F
IG. 88.
3. Program mode at the PC times-out after 5 minutes.
If this happens, close the programming window and
click Program Link For The Appropriate Meter
again.
4. Put the meter into programming mode. While on a
screen that shows ACTIVATE above the entry but-
tons, simultaneously press and hold down both right
and left buttons until the meter’s screen indicates
PROGRAM MODE. Press the PROGRAM button.
See instruction manual 309497 for more details.
5. The meter sends a programming request to the PC,
which replies with that meter’s configuration set-
tings. When complete, the meter restarts itself, and
begins using the new settings.
Graco recommends that the meter be programmed
at the same location as the PC. If this is not possi-
ble, make sure the meter is receiving a strong RF
signal from the transceiver prior to programming.
F
IG. 87
Only one meter or tank level monitor can be pro-
grammed at a time
M
e
t
e
r
1
5
W
-
3
0
FIG. 88 Meter Programming Screen