Filter
Top Products
201
Enhancements in Release F.02.02
New Time Synchronization Protocol Options
iii. Press [>] to move the cursor to the Poll Interval field, then go to step 6.
6. In the
Poll Interval field, enter the time in minutes that you want for a TimeP Poll Interval.
Press
[Enter] to return to the Actions line, then [S] (for Save) to enter the new time protocol
configuration in both the startup-config and running-config files.
CLI: Viewing and Configuring TimeP
CLI Commands Described in this Section
This section describes how to use the CLI to view, enable, and configure TimeP parameters.
Viewing the Current TimeP Configuration
This command lists both the time synchronization method (TimeP, SNTP, or None) and the TimeP
configuration, even if SNTP is not the selected time protocol.
Syntax: show timep
For example, if you configure the switch with TimeP as the time synchronization method, then enable
TimeP in DHCP mode with the default poll interval,
show timep lists the following:
Figure 97. Example of TimeP Configuration When TimeP Is the Selected Time Synchronization Method
show timep page 201
[no] timesync page 202 ff., 204
ip timep
dhcp page 202
manual page 203
server <ip-addr> page 203
interval page 204
no ip timep page 205