Filter
Top Products
229
Software Fixes
Release F.01.08
Fixed in release F.01.08:
■ 100/1000-T transceiver — When using this 100/1000-T transceiver and negotiating to 100
Mbps, the port may report that it is operating at 100 full duplex, when it is actually operating
at 100 half duplex.
■ Web-Browser Interface — The product label in the Web-browser display for the Switch
2512 is incorrectly displayed as
Switch 2524.
Release F.01.09 (Beta Release Only)
Fixed in release F.01.09:
■ Console/Management — A console and management (SNMP, telnet, etc.) hang may occur
when an illegal MAC address is detected on a port configured with a port security action of
"send-disable".
Release F.01.10
Fixed in release F.01.10:
■ Port Security — The switch does not send an alarm upon a port security violation when
the port security learn-mode is "continuous" and the action is "send-alarm".
■ Port Security — If the configuration is not saved (i.e., write mem) before the switch is
rebooted, the learned addresses are not saved.
■ Port Security — A port that has been disabled due to a security violation does not remain
disabled after the switch is rebooted.
Release F.02.02
This release adds the following new features:
■ TACACS+
■ CDP (Cisco® Discovery Protocol)
■ SNTP
■ Improved IGMP capabilities
For details about the above enhancements, refer to “Enhancements in Release F.02.02” on page 164.