Filter
Top Products
40
Enhancements in Release F.05.05 through F.05.70
Enhancements in Release F.05.05 through F.05.60
Syntax: aaa port-access authenticator < port-list > (Syntax Continued)
[quiet-period < 0 - 65535 >]
Sets the period during which the port does not try to acquire
a supplicant. The period begins after the last attempt autho-
rized by the max-requests parameter fails (next page).
(Default: 60 seconds)
[tx-period < 0 - 65535 >]
Sets the period the port waits to retransmit the next EAPOL
PDU during an authentication session. (Default: 30
seconds)
[supplicant-timeout < 1 - 300 >]
Sets the period of time the switch waits for a supplicant
response to an EAP re quest. If the supplicant does not
respond within the configured time frame, the session times
out. (Default: 30 seconds)
[server-timeout < 1 - 300 >]
Sets the period of time the switch waits for a server response
to an authentication request. If there is no response within
the configured time frame, the switch assumes that the
authentication attempt has timed out. Depending on the
current max-requests setting, the switch will either send a
new request to the server or end the authentication session.
(Default: 30 seconds)
[max-requests < 1 - 10 >]
Sets the number of authentication attempts that must time-
out before authentication fails and the authentication
session ends. If you are using the Local authentication
option, or are using RADIUS authentication with only one
host server, the switch will not start another session until a
client tries a new access attempt. If you are using RADIUS
authentication with two or three host servers, the switch will
open a session with each server, in turn, until authentica-
tion occurs or there are no more servers to try. During the
quiet-period (previous page), if any, you cannot reconfigure
this parameter. (Default: 2)