HP (Hewlett-Packard) 2500 Switch User Manual


 
214
Enhancements in Release F.02.02
Operation and Enhancements for Multimedia Traffic Control (IGMP)
CLI: Configuring Per-Port Forced Fast-Leave IGMP
In the factory-default configuration, Forced Fast-Leave is disabled for all ports on the switch. To
enable (or disable) this feature on individual ports, use the switch’s MIB commands, as shown below.
Syntax: setmib hpSwitchIgmpPortForcedLeaveState.1.<port-number> -i < 1 | 2 >
or
setmib 1.3.6.1.4.1.11.2.14.11.5.1.7.1.15.3.1.5.1.<port-number> -i < 1 | 2 >
where:
1 = Forced Fast-Leave enabled
2 = Forced Fast-Leave disabled
For example, to enable Forced Fast-Leave on ports 7 and 8:
Figure 108. Example of Changing the Forced Fast-Leave Configuration on Ports 7 and 8
Command
Verification