Filter
Top Products
70
Enhancements in Release F.05.05 through F.05.70
Enhancements in Release F.05.05 through F.05.60
Notes
Any port VLAN-ID changes you make on 802.1X-aware ports during an 802.1X-authenticated session
do not take effect until the session ends.
With GVRP enabled, a temporary, untagged static VLAN assignment created on a port by 802.1X
authentication is advertised as an existing VLAN. If this temporary VLAN assignment causes the
switch to disable a configured (untagged) static VLAN assignment on the port, then the disabled
VLAN assignment is not advertised. When the 802.1X session ends, the switch:
■ Eliminates and ceases to advertise the temporary VLAN assignment.
■ Re-activates and resumes advertising the temporarily disabled VLAN assignment.
Messages Related to 802.1X Operation
Table 6. 802.1X Operating Messages
Message Meaning
Port < port-list > is not an authenti-
cator.
The ports in the port list have not been enabled as 802.1X
authenticators. Use this command to enable the ports as
authenticators:
HPswitch(config)# aaa port-access
authenticator e 10
Port < port-list > is not a supplicant. Occurs when there is an attempt to change the supplicant
configuration on a port that is not currently enabled as a
supplicant. Enable the port as a supplicant and then make
the desired supplicant configuration changes. Refer to
“Enabling a Switch Port To Operate as a Supplicant” on
page 58.
No server(s) responding. This message can appear if you configured the switch for
EAP-RADIUS or CHAP-RADIUS authentication, but the
switch does not receive a response from a RADIUS server.
Ensure that the switch is configured to access at least one
RADIUS server. (Use show radius.) If you also see the
message Can’t reach RADIUS server <
x.x.x.x >
, try the suggestions listed for that message
(page 127).