Filter
Top Products
If Manual: Use the number buttons on the front panel of the PSA to enter the
IP address. Then press
.
If DHCP: Press to continue.
If Manual: Use the number buttons on the front panel of the PSA to enter the
subnet mask. Press
.
If DHCP: Press to continue.
If Manual: Use the numbers on the front panel of the PSA to enter the
default gateway. Press
.
If DHCP: Press to continue.
Press .
Press .
After a moment, the PSA will resume displaying normal operating messages if
the IP address is valid.
Configuring the Link Speed and Duplex Mode Using the Front Panel
These procedures explain how to configure the link speed (100 Mbps or 10 Mbps) and the duplex mode (full or half) for
the PSA using the front panel. This can be done manually or the settings can be automatically detected (which is the
default). The link speed is the speed at which the PSA communicates over the network. The speed is expressed in
megabits per second and is either 10 or 100. The duplex mode defines whether data can be sent at the same time it is
received:
● Full duplex: data can flow both directions at the same time
● Half duplex: data can only flow one way at a time and any attempt to do both at the same time creates a
collision.
The current setting is displayed on the System Summary page (under Maintenance in the web interface).
Display Action