Filter
Top Products
124 Chapter2
Opening Your Personal Workstation and Installing Accessories
Installing and Removing a Processor
4. Install the processor in its connector on the system board. To do this,
pull outward on the right connector’s retainer tab (relative to the top
of the Personal Workstation) and push inward on the right edge of the
processor board. You will need to do the same thing to the left side of
the processor. See Figure 2-85. Note that you can hold the processor’s
heat sink in the had you are not using for pushing; however, the heat
sink should not be used as a handle for removing or replacing the
processor.
Figure 2-85 Installing the Processor
Press down firmly on the processor and terminator card to ensure
they are properly seated in their connectors.
Retainer Tab
Processor
Terminator
Card
Processor
Heat Sink