Filter
Top Products
Chapter 2 133
Opening Your Personal Workstation and Installing Accessories
Installing and Removing a Voltage Regulator Module (VRM)
5. Install the VRM into its connector on the system board. See Figure
2-93 and Figure 2-94. Note that the arrow points to the top inside of
the Personal Workstation.
Figure 2-93 Installing the Voltage Regulator Module (VRM)
Figure 2-94 Installed Voltage Regulator Module (VRM)
6. Ensure all cables internal to the Personal Workstation are clear of
any sharp edges or hot components. Next replace the left-side panel of
the Personal Workstation as explained in the section “Replacing the
Left-Side Panel” in this chapter.
Voltage
Regulator
Module (VRM)
VRM Connector
Top
Voltage
Regulator
Module
Top