Filter
Top Products
Using HP Jetdirect print server cards
Follow these procedures to install or remove an EIO card.
Install an HP Jetdirect print server card
1. Turn off the device.
2. Remove the two screws and cover plate from the EIO slot on the back of the device.
NOTE: Do not discard the screws or the cover plate. Save them for future use if you remove the
EIO card.
3. Install the EIO card in the EIO slot and tighten the screws.
4. Connect the network cable to the EIO card.
5. Turn on the device, and then print a configuration page to verify that the new EIO device is
recognized. See
Use information pages on page 146.
NOTE: When you print a configuration page, an HP Jetdirect configuration page that contains network
configuration and status information also prints.
ENWW Using HP Jetdirect print server cards 255