Filter
Top Products
Legato NetWorker, Release 7.0
Disaster Recovery Guide
5
Recovering a Replicated NDS Partition
108
e. Press [Enter], and both the files and NDS are copied to the new
server. DSMISC.LOG, VOLSINFO.TXT, and AUTOEXEC.NCF are
copied to the SYS:SYSTEM directory. STARTUP.NCF is copied to the
C:\NWSERVER directory.
f. The NDS restoration uses the information from SERVDATA.NDS
(TSANDS.NLM is not needed). NDS is now fully functional on the
server, but the partitions and replicas must still be reestablished.
g. When prompted, insert the NetWare License diskette for the server
into the diskette drive.
h. Edit the STARTUP.NCF and AUTOEXEC.NCF files.
i. If either the STARTUP.NCF or the AUTOEXEC.NCF files have
changed because they were backed up with the server-specific
information, both the original and the new files are displayed for you
to compare and make edits as necessary. If the current files are the
same as the original files, only the current files are displayed.
The server now contains all the files necessary to perform an SMS remote
filesystem restore.
3. To finish the installation:
• Press Enter to exit the utility. NetWare will not copy the remaining
system and public files but will exit the utility. These files should be
recovered from a backup.
• Alternatively, press F3 to Continue installation and wait while the
utility copies the remaining system and public files. Then exit.
Task 3: Complete the NetWare SYS Volume Recovery
This section describes how to complete the recovery of the 4.11 SYS volume.
To complete the recovery of the 4.11 SYS volume:
1. Load the required name space modules for each restored volume. Use the
VOLSINFO.TXT file to determine which name spaces need to be loaded
(MAC.NAM, OS2.NAM, and so on).
2. Load the filesystem TSA specific to your version of NetWare by entering
one of the following commands on the repaired or replaced server:
LOAD TSA410
LOAD TSA500