Filter
Top Products
Legato NetWorker, Release 7.0
Disaster Recovery Guide
Chapter 4: Windows Disaster Recovery
4
67
How to Recover a Windows 2000 NetWorker Server
To recover a Windows 2000 NetWorker server, perform the following tasks in
the order specified:
• “Task 1: Install the NetWorker Server Software” on page 67
• “Task 2: Configure the NetWorker Server” on page 68
• “Task 3: Locate the NetWorker Server Bootstrap Save Set ID” on page 70
• “Task 4: Recover the NetWorker Server Bootstrap” on page 72
• “Task 5: Rename the Resource Configuration Files” on page 74
• “Task 6: Reset and Inventory the Autochanger” on page 74
• “Task 7: Recover the NetWorker Server’s Client File Indexes” on page 76
• “Task 8: Recover the NetWorker Server Data” on page 78
• “Task 9: Restore the Removable Storage Jukebox Configuration” on page
80
• “Task 10: Verify the NetWorker Server Recovery” on page 81
Important: When recovering a NetWorker server that was also being used as
a Legato License Manager server (not recommended), the lictype.res file of the
Legato License Manager is not restored during the NetWorker server
recovery. This is because the Legato License Manager files and directories are
not considered part of the NetWorker software. After completing the disaster
recovery on the NetWorker server, you must explicitly recover the Legato
License Manager as a client of the NetWorker server.
Task 1: Install the NetWorker Server Software
Important: If you updated from NetWorker release 6.x and have not yet
performed a scheduled backup of the NetWorker server, reinstall NetWorker
release 6.x and use it to recover the bootstrap, then update the NetWorker
software and proceed with the recovery.
To install the NetWorker server software:
1. Install to its original path location the release of the NetWorker server
software that was in use prior to the disaster. For instructions, refer to the
Legato NetWorker Installation Guide, Microsoft Windows Version.