Filter
Top Products
Legato NetWorker, Release 7.0
Disaster Recovery Guide
Chapter 3: UNIX Disaster Recovery
3
45
7. Reboot the computer when the recovery is complete. The computer should
now be restored as it was prior to the disaster.
Note: By default, the directed recover option is enabled when you install the
NetWorker client. If the directed recover option was disabled on the client
before the disaster, you need to explicitly set this option to disable directed
recoveries to this client. This option is set through the nsradmin command. For
more information about setting the disable directed recover option on the
NetWorker client, refer to the Legato NetWorker Administrator’s Guide, UNIX
Version.
Task 3: Perform a Test Backup and Recovery
To test the NetWorker client backup and recovery process:
1. Perform a test backup using each of the Legato backup utilities
incorporated into the backup solution.
2. Perform a test recovery using the Legato utility used to back up the data.
For details, refer to the Legato NetWorker Administrator’s Guide.