Filter
Top Products
Legato NetWorker, Release 7.0
Disaster Recovery Guide
4
Recovery Requirements
64
3. In the hosts file (%SystemRoot%\system32\drivers\etc\hosts) make an entry
for the NetWorker server to be used in the recovery. NetWorker software
requires this entry when:
• DNS is not in use or no DNS server is available
• The NetWorker server host you are recovering is also a DNS server
The entry in the hosts file must include the IP address, the fully qualified
domain name, and the computer name, all on the same line. For example:
123.56.890.474 kingdome.seattle.washington.com kingdome
4. Configure the virtual memory as it was prior to the disaster:
Windows .NET and Windows XP Professional:
a. Start the Control Panel System tool.
b. In the System Properties dialog box, select the Advanced tab and
click Settings in the Performance section.
c. In the Performance Options dialog box, select the Advanced tab and
click Change in the Virtual Memory section.
d. In the Virtual Memory dialog box, set the virtual memory options.
Click OK.
Windows 2000:
a. Start the Control Panel System tool.
b. In the System Properties dialog box, select the Advanced tab and
click Performance Options.
c. In the Performance Options dialog box, click Change.
d. In the Virtual Memory dialog box, set the virtual memory options.
Click OK.
Windows NT 4.0:
a. Start the Control Panel System tool.
b. In the System Properties dialog box, select the Performance Tab.
c. On the Performance tab, click Change.
d. In the Virtual Memory dialog box, set the virtual memory options.
Click OK.
5. Reinstall any additional Windows components previously installed
through Windows Setup, such as Gateway Services for NetWare.
Note: Do not upgrade OEM drivers for network interface cards (NIC) with the
OEM Service Pack version of the NIC drivers.