Filter
Top Products
Legato NetWorker, Release 7.0
Disaster Recovery Guide
6
Task 2: Replace the Hard Drive
114
2. If the current shared disk’s resource group contains the shared disk and its
dependent resources, move the cluster resources that represent the
affected shared disk into the resource group you created in the previous
step.
3. Take offline the resource group that contains the shared disk.
Note: You do not need to create a new resource group if the shared disk’s
resource group only contains resources that depend on it.
Task 2: Replace the Hard Drive
For more information, refer to the Microsoft Cluster Server documentation.
To replace the hard drive:
1. Using the Control Panel Services tool, set the Startup Type of the Cluster
Service to Manual.
2. In the Cluster Administrator program, open the Property window for each
resource in the resource group. Select the Do Not Restart property from the
Advanced window.
3. Remove the shared disk from the dependency list of any resources that
depend on the shared disk.
Important: If you fail to perform this step, you may not be able to delete the
disk resource in the following step.
4. Delete the cluster resource that represents the shared disk.
5. If required, shut down the nodes.
Note: Refer to the MSCS Cluster Hardware Manual to determine whether
you must shut down the nodes before you replace the shared disk.
6. Remove the shared disk and replace it with a new shared disk.
7. If you have shut down the nodes, reboot them.
8. Create the drive volumes and format the new disk as the old one was.