Filter
Top Products
Legato NetWorker, Release 7.0
Disaster Recovery Guide
5
Completing the Recovery Process
94
Task 3: Test the Operating System and Configure Devices
To test the operating system and configure the devices:
1. Configure any devices the NetWorker software requires. For example,
SCSI pass-through devices for autochangers.
2. Perform a test to verify that the:
• Name to Address resolution is correct. Test by running nslookup
using the Fully Qualified Domain Name of the NetWare NetWorker
backup server, client, or storage node.
• Network protocols are functioning properly.
• Operating system is functioning properly.
• Time synchronization is functioning properly.
• The operating system recognizes the devices. If the operating system
does not recognize the devices, you might need to:
– Modify the device configuration files to enable the computer to
communicate with the device during recovery.
– Load the SCSI driver and its associated ASPI driver.
– Install the device driver.
Completing the Recovery Process
To complete the recovery process after installing and configuring the
operating system, use the following procedures, depending on the type of
NetWorker computer you are recovering:
• “Recovering a NetWare NetWorker Server” on page 94
• “Recovering a Replicated NDS Partition” on page 102
Note: To recover computer data using the NetWorker software, refer to the
Legato NetWorker Administrator’s Guide, NetWare Version.
Recovering a NetWare NetWorker Server
The following sections provide information on recovering a NetWorker
server:
• “Prerequisites” on page 95
• “How to Recover a NetWare NetWorker Server” on page 95