Filter
Top Products
Legato NetWorker, Release 7.0
Disaster Recovery Guide
Chapter 4: Windows Disaster Recovery
4
51
• For Windows 2000 NetWorker clients (or Windows .NET or
Windows XP Professional clients for which an ASR disk or save set is
not available), reinstall the operating system if necessary. For
instructions, see “Recovering a Windows Installation” on page 60.
• For Windows NT 4.0 NetWorker clients, repair the operating system
if necessary. For instructions, see “Repairing a Windows NT 4.0
Operating System Installation” on page 57.
3. Ensure that the recovery requirements are satisfied. For instructions, see
“Task 1: Satisfy the NetWorker Client or Storage Node Recovery
Requirements” on page 83.
4. Reinstall the NetWorker software, if necessary. For instructions, see “Task
2: Reinstall the NetWorker Client or Storage Node Software” on page 83.
5. Recover the data and SYSTEM save sets using the NetWorker User
program. For instructions, see “Task 3: Recover the NetWorker Client or
Storage Node Data” on page 84.
6. Reboot the computer after the recovery is complete.
7. Verify the recovery. For instructions, see “Task 4: Verify the NetWorker
Client or Storage Node Recovery” on page 86.
Disaster Recovery of Multiple Computers
If you are performing disaster recovery on more than one computer, recover
the computers in the following order:
1. The NetWorker server
2. The NetWorker storage nodes (if any) used by the NetWorker server
3. The NetWorker clients associated with the NetWorker server
Note: If the backup device to be used for the recovery is connected to a storage
node, you might have to perform a partial recovery of the storage node before
you begin recovery of the NetWorker server. For more information, see
“Recovering a NetWorker Client or Storage Node” on page 82.