Filter
Top Products
Legato NetWorker, Release 7.0
Disaster Recovery Guide
Chapter 6: Microsoft Cluster Disaster Recovery (Windows NT 4.0)
6
121
5. Install the MSCS software.
6. Install any required service pack software. Make sure that the version is
greater than Service Pack 3.
7. If Node_A is a NetWorker server, configure the tape devices.
8. Log on to Node_A using the cluster account on the domain.
Task 2: On Node_B, Install and Configure the Software
To install and configure the software, on Node_B:
1. Make sure the node has been properly:
•Shut down
• Connected through the shared disks
•Terminated
2. Install Windows NT 4.0 Server Enterprise Edition.
a. Add the server to the domain using the same cluster login account.
b. Create the partitions so the new disk configuration matches the
original configuration.
c. Use the same server name (fully qualified DNS if used) and IP
address that were used originally.
d. Configure the network adapters and the IP address using the original
settings whenever possible.
e. Log on to the domain.
3. Using the Windows NT Disk Administrator, configure the drives to match
their previous configuration.
4. Install Windows NT 4.0 Server Enterprise Edition server-specific service
packs (Service Pack 3).
Task 3: Install and Configure NetWorker
Install and configure the NetWorker software and any required patches on
Node_A and Node_B. For details, refer to the Legato NetWorker Installation
Guide, Microsoft Windows Version.