Filter
Top Products
Chapter 1 • Introduction
1037753-0001 Revision A
3
Commissioning
Commissioning is the process of registering an HN router for
service. During the commissioning process you may use auto
selection or manual entry of parameters.
• Auto Selection - Allows you to choose the Network Access
Provider (NAP) from a predetermined list of providers. Many
of the commissioning parameters are automatically
configured for the provider chosen.
• Manual Entry - This mode requires you to enter all
parameters manually.
Associated transport
devices
Installation and commissioning of the HN router requires
configuring/commissioning tasks for the transport device. This
version of the Installation Guide provides information on the
following:
• ADTRAN Total Access 600R as described in Appendix E –
ADTRAN Total Access 600R, on page 99.
• Siemens Model 4100/4101 as described in Appendix F –
Siemens 4100/4101 DSL Modem, on page 117.
Safe operating
temperature range
5 to 40°C (Above 5000 ft altitude, reduce maximum temperature by 1°C per
1000 ft)
Safe operating
humidity range
5% to 95% non-condensing
Safe altitude 10,000 ft
Cooling method Convection
Main processor 300 MHz
Main memory 64 Mbyte
Flash memory 16 Mbyte
Protocol support TCP/IP (Transmission Control Protocol / Internet Protocol) protocol suite
Interfaces/ports • Two Ethernet ports supporting 10BaseT or 100BaseT operation, RJ45-switched
• Telephone line port
• Serial port, DTE/DCE RS-232, which supports the following protocols:
– VISA (Veriphone 3200 and 3300) (the asynchronous protocol of Vanguard
International Service Association credit card)
– X.25 International Telecommunication Union-Telecommunication
Standardization Sector (ITU-T) protocol standard for WAN communications
– XPAD (X.25 Packet Assembler/Disassembler)
– SDLC (Synchronous Data Link Control)
– LLC (Logical Link Control)
Power supplies and
power requirements
See Table 2 on page 11.
Table 1: Specifications for the HN router