Filter
Top Products
Chapter 5 • Commissioning the HN router
1037753-0001 Revision A
19
Chapter 5
Commissioning the HN router
This chapter explains how to commission the HN router. It
includes the following topics.
• Router connections on page 19
• Commissioning procedures on page 19
• Changing from VSAT to router mode on page 20
• Terrestrial Broadband Setup page on page 22
• Commissioning by auto selection on page 24
• Completing the commissioning process on page 30
• Commissioning by manual entry on page 33
Router connections
Make sure you have made all the proper connections before you
begin.
• Verify the installer laptop is connected to the HN router’s
LAN1 port.
• Verify the transport device is connected to the HN router’s
LAN2 port.
The appendices contain instructions for connecting the HN router
to the various transport devices.
• Refer to Connecting the cables to a modem transport device
on page 15 or Connecting the cables to a T-1 transport device
on page 16 for instructions on how to connect the cables.
If the HN router does not assign the IP address 192.168.0.1 to the
installer PC, restart the installer PC to obtain the IP address.
Commissioning
procedures
Commissioning the router consists of the following tasks:
• Accessing the System Control Center page to use the
Advanced Commissioning Options link to display the Setup
link.
• Accessing the mode change link to change the mode from
VSAT to router mode.
• Selecting the Configuration File Upload link.
• Selecting the Registration Installer link.