Filter
Top Products
86 J.D. Edwards’ OneWorld B73.3 and Windows Terminal Server
6.4 SoftwareGuide CD-ROM with Windows Terminal Server Edition
When using SoftwareGuide to install Windows NT Server 4.0, Terminal Server
Edition, you must copy the necessary device drivers to diskettes and use these
diskettes during the installation of Windows NT Server 4.0, Terminal Server
Edition. Terminal Server Edition is installed via its diskettes and CD-ROM (you
must use the shrink-wrap version).
Note: At the time of writing, ServerGuide does not support Windows NT Server
4.0, Terminal Server Edition.
After using HardwareGuide, you should use SoftwareGuide to prepare your
system for the Terminal Server Edition installation. Complete the following steps
to create the necessary diskettes:
1. Place the SoftwareGuide CD-ROM into the server and reboot.
2. At the main menu, click Diskette Factory.
3. Under Select a Category, you should see Your Server selected as the default.
Click > to continue.
4. Check the packages that appear on the screen. In our example, we used an
IBM Netfinity 5000 as our Windows Terminal Server and selected:
• IBM Netfinity 5000 System Diskettes
• IBM ServeRAID Adapter
Click > to continue.
5. In our example, the diskettes we selected to create from the packages were:
• 7800 Family Manager Set Disk 1 of 2
• IBM ServeRAID Device Driver Diskette
• IBM Netfinity S3 Trio V2/GX Device Driver for NT
• IBM Netfinity, PC Srvr Ethernet Ctrlr and IBM Netfinity 10/100 Fault
Tolerant Dev Drvr.
6. Click > to begin creating your diskettes. After all the diskettes have been
completed, click < four times to return to the ServerGuide exit dialog box and
click OK.
7. Remove the CD-ROM and then click OK.
8. Continue with the installation of Windows NT Server 4.0, Terminal Server
Edition using the diskettes and CD-ROM shipped with the product.