Filter
Top Products
__ 1. It is Version 5.0 or higher if you are planning to update multiple
databases within the same transaction; if you are planning to use
2-phase commit then Version 5.01 of CS/NT is required
__ 2. The IBM Communications Server IEEE 802.2 LAN interface was
installed (this is an installation option for Communications Server)
__ 3. The APAR fixes JR11529 and J$11170 were applied. These fixes are
required to enable cancelling of queries in progress by using
Ctrl-BREAK or issuing the SQLCancel ODBC/CLI call.
__ 4. The LLC2 driver was installed from the CS/NT installation directory.
During installation CS/NT asks if you want to install LLC2. If you are
not sure whether LLC2 was installed with your copy of CS/NT, you
can find out as follows:
a. Click on the Start push button, then select Settings->Control Panel.
b. Double-click on the Network icon.
c. On the Network window, click on the Protocols tab. IBM LLC2
Protocol must be one of the protocols listed. If it is not, you need to
install this protocol from your IBM Communications Server for
Windows NT software. Refer to documentation supplied with
CS/NT for instructions.
To start IBM eNetwork Personal Server, perform the following steps:
Step 1. Click on the Start button and select Programs->IBM
Communications Server-> SNA Node Configuration. The IBM
Communications Server SNA Node Configuration window opens.
Step 2. Select File->New->Advanced from the menu bar. The Configuration
options window opens. Subsequent steps will begin from this
Chapter 7. Configuring APPC Communications on the DB2 Connect Workstation 71