Filter
Top Products
c. In the Partner LU alias field, type in the partner LU name (2)
from the worksheet (NYM2DB2).
d. If you are configuring Communications Server for SNA Clients, in
the Fully-qualified CP name fields, type in the network ID (3)
and the adjacent control point SSCP name (4)(SPIFNET.NYX).
Leave the other fields blank.
e. Click on OK.
Step 6. Configure Modes
a. In the Configuration options field, select Configure modes, then
click on the New button. The Define a mode window appears.
b. In the Mode name field (6), type in the mode name (IBMRDB).
c. Click on the Advanced tab and ensure that the Class of Service
Name is set to #CONNECT.
Accept the defaults for the other fields.
d. Click on OK.
Step 7. Configure Local LU 6.2
a. In the Configuration options field, select Configure local LU 6.2,
then click on the New button. The Define a local LU 6.2 window
appears.
b. In the Local LU name field, type in the name (11)fromthe
worksheet (NYX1GW01).
c. Type in a value for the LU session limit field. The default, 0,
specifies the maximum allowed value.
Accept the defaults for the other fields.
d. Click on OK.
Step 8. Configure CPI-C Side Information
a. In the Configuration options field, select Configure CPI-C side
information, then click on the New button. The Define CPI-C side
information window appears.
b. In the Symbolic destination name field, type in the name (16)
from the worksheet (DB2CPIC).
c. In the Mode name field, type in the name (15)fromthe
worksheet (IBMRDB).
d. Click on the radio button beside Use Partner LU alias and select
a Partner LU alias.
e. Specify the TP name. In the TP name field:
v To specify a non-service TP, in the TP name field, type in the
name of the non-service TP, for example DB2DRDA, and ensure
that there is no check mark in the Service TP check box.
74 Quick Beginnings