Filter
Top Products
When “Call for Service” Message Is Displayed (continued)
5-3
3. Unplug the machine.
4. Contact your service representative and report the condition and
code No.
Limited Use of the Copier in Trouble
If the message shown below is displayed on the Call for Service Screen, you may
continue operating the copier on a limited function basis and utilize the trays and ADU
that are not affected by the trouble. To obtain this limited functionality of the copier,
consult your service representative. Be sure to utilize the limited function only
temporarily, and arrange for machine repair immediately.
1. If the limited use of the copier is available, the following message is
displayed in the message area instead of the Report code.
ex. Tray 2 failure
Press AUTO to select except this tray
2. Press [AUTO RESET].
Please switch ON/OFF
E 18-2
Make note of the Report code No.
3. Turn OFF then ON the power switch.
A copying job can continue without using the troubled portion of the machine (ex. Tray
2).
CAUTION
EVEN IF THE COPYING JOB CAN BE CONTINUED WITH THE
ABOVE OPERATION, BE SURE TO CONTACT YOUR SERVICE
REPRESENTATIVE IMMEDIATELY WHEN THE CALL FOR
SERVICE SCREEN IS DISPLAYED.
5
Trouble-
shooting
Call for
Service
Preventive
Maintenance
Clearing
Mishandled
Paper
JAM Key
ADD PAPER
Key
Memory
Overflow
Power OFF/ON
Screen
Troubleshooting
Tips