Lathem FR700 Time Clock User Manual


 
PAYCLOCK & FACEIN USER’S GUIDE
84
Appendix C - Connecting the FaceIN
Directly to the Computer’s NIC
This document describes the steps to configure FaceIN terminal to
communicate with the PayClock database server when connecting
directly into the computers wired NIC. This would be used when the
user doesn’t have a network setup and has a computer that has a
wired NIC.
Step #1 - At the Computer where PayClock is installed
See the More Information section for Windows XP, Vista and
Windows 7 directions for accessing the NIC properties.
Open the Properties of the NIC.
Open the Properties of the Internet Protocol item.
Define the IP (10.0.1.1) and Subnet Mask (255.0.0.0).
Step #2 - Connect the Ethernet cable to the computer and
FaceIN
The computer will go through the process of acquiring the IP
connection.
Step #3 - At the FaceIN terminal
Press the MENU key, the Functions Menu will open.
Press 4, the System Setting menu will open.
From the System Setting menu, press 2 - Set Network.
Enter the IP Address for the terminal (using the computer’s
IP as reference, i.e. 10.0.1.2) and press OK.
Enter the Mask (same as what was entered at the pc, i.e.
255.0.0.0) Code and press OK.
Leave the Gateway at the default (blank) and press OK.
The FaceIN terminal will restart automatically.
Note: You may have to enter leading zeros when entering the
addresses. For example, the address 10.0.0.1 would be entered as
010.000.000.001 at the terminal.