Filter
Top Products
This topic provides instructions on how to install the TR 500 Key on a ThinkServer RAID 500 Adapter if your
server has a ThinkServer RAID 500 Adapter installed.
Attention: Back up your data before you begin if you want to recongure RAID and reinstall the operating
system after installing the TR 500 Key.
Before you begin, print all the related instructions or ensure that you can view the PDF version on another
computer for reference.
Note: Use any documentation that comes with the TR 500 Key and follow those instructions in addition to
the instructions in this topic.
To install the TR 500 Key, do the following:
1. Remove all media from the drives and turn off all attached devices and the server. Then, disconnect all
power cords from electrical outlets and disconnect all cables that are connected to the server.
2. If the server is installed in a rack cabinet, remove the server from the rack cabinet and place it on a at,
clean, and static-protective surface. See the Rack Installation Instructions that comes with the server.
3. Remove the server cover. See “Removing the server cover” on page 69.
4. Remove the cooling shroud. See “Removing and reinstalling the cooling shroud” on page 73.
5. Locate the ThinkServer RAID 500 Adapter, which is installed in the PCI Express card slot on the riser
card assembly 2. Then, disconnect any cables from the ThinkServer RAID 500 Adapter.
6. Remove the riser card assembly 2 and lay it upside down on a at, clean, and static-protective surface.
The procedure is similar to that of the riser card assembly 1. See “Replacing the riser card assembly
1” on page 143
.
7. Touch the static-protective package that contains the TR 500 Key to any unpainted surface on the
outside of the server. Then, take the TR 500 Key out of the package.
Note: Carefully handle the TR 500 Key by its edges.
90 ThinkServer RD330 User Guide