Lenovo 4302 Server User Manual


 
7. Reconnect external cables and power cord(s) to the server. See “Rear view of the server” on page 20 to
identify the connectors on the rear panel of the server.
Attention: To avoid component damage, connect the power cord(s) last.
Note: In most areas of the world, Lenovo requires the return of the defective CRU. Information about this will
come with the CRU or will come a few days after the CRU arrives.
Updating the server conguration
When you turn on the server for the rst time after you install, remove, or replace a device, you might
need to update the server conguration.
Some optional devices have device drivers that you must install. For information about installing device
drivers, use the documentation that comes with each optional device. To obtain the supported device drivers
for your server from the Lenovo Support Web site, go to http://www.lenovo.com/drivers, and then follow the
instructions on the Web page to nd and download the device drivers you need.
Refer to the following information resources to update the server conguration:
To update the BIOS conguration, see “Using the Setup Utility program” on page 45
.
To update the RAID conguration, see “Conguring RAID” on page 56.
To use the ThinkServer EasyStartup program, see “Using the ThinkServer EasyStartup program” on
page 53.
To update your system rmware, see “Updating the rmware” on page 64.
Chapter 6. Installing, removing, or replacing hardware 151